西岱尔1000M网络端口避雷器PL24-CAT6

This range of surge protectors is designed to protect data processing equipment,
connected to twisted pair Ethernet 10 to 1000 Mbit/s network (10BaseT
or 100BaseT), against lightning or switching surges.
Electrical diagrams used are based on miniature GDT and clamping diode
network in order to provide a maximum efficiency and a minimum low losses.
These surge protectors are equipped with standard RJ45 connector for easy
installation.
Several versions are available :
MJ8-2ETH : Basic version to protect one terminal connected to an unshielded
10BaseT network (UTP). Featured with in/out RJ45 connectors. Fast wall
or frame mounting by self-gripping fasteners.
MJ8-C6 : surge protector dedicated to protect terminals on100/1000BaseT
UTP networks. Compliance with «Cat5/6» standard. All of the 8 wires are
protected. Featured with in/out RJ45 connectors. Easy mounting directly on
cable.
ZS-CAT6/CL : Version designed to protect one terminal connected to a
1000BaseT «Category 6» network. Shielded enclosure equipped with in/out
RJ45 connectors. All the 8 wires are protected. These surge protectors for
remote terminals are used in association with a multiline rack surge protection
(PL24-CAT5/CL), centralized protection at the hub level.
PL24-CAT6/CL : This 19’’ panel is designed for the surge protection of
multi-line inputs of a Category 6 - 1000BaseT STP network at the hub level.
The maximum capacity is 24 channels with the PL24-CAT5/CL panel (12
channels with the PL12-CAT6/CL panel). The 19’’ format, 1HE high (44 mm),
allows installation in all standard cabinets. The product uses shielded RJ45
connectors. The circuit diagram and construction allow a bit rate of 1000
Mbps and ensure Category 5 conformity. All 8 wires of each RJ45 connector
are protected
MJ8-505 : Designed for «PoE» network (Power over Ethernet , IEEE802-3af
std), this surge protector is useful for the HotPoints used in WiFi networks or
for the IPBX terminals . Protection of the 100BaseT transmission and up to 60
Vdc power supply. Equipped with in/out unsheilded RJ45 connectors.